//     ,   :
  //Serial.begin(115200);

// () {
  // put your main code here, to run repeatedly:
  //delay(10); // this speeds up the simulation
/*
 * This ESP32 code is created by esp32io.com
 *
 * This ESP32 code is released in the public domain
 *
 * For more detail (instruction and wiring diagram), visit https://esp32io.com/tutorials/esp32-potentiometer-triggers-led
 */







/*
 * This ESP32 code is created by esp32io.com
 *
 * This ESP32 code is released in the public domain
 *
 * For more detail (instruction and wiring diagram), visit https://esp32io.com/tutorials/esp32-potentiometer-triggers-led
 */

#define POTENTIOMETER_PIN  36  // ESP32 pin GPIO36 (ADC0) connected to Potentiometer pin
#define LED_PIN            21  // ESP32 pin GPIO21 connected to LED's pin
#define VOLTAGE_THRESHOLD  2.5 // Voltages

void setup() {
  pinMode(LED_PIN, OUTPUT); // set ESP32 pin to output mode
}

void loop() {
  int analogValue = analogRead(POTENTIOMETER_PIN);      // read the input on analog pin
  float voltage = floatMap(analogValue, 0, 1023, 0, 5); // Rescale to potentiometer's voltage

  if (voltage > VOLTAGE_THRESHOLD)
    digitalWrite(LED_PIN, HIGH); // turn on LED
  else
    digitalWrite(LED_PIN, LOW);  // turn off LED
}

float floatMap(float x, float in_min, float in_max, float out_min, float out_max) {
  return (x - in_min) * (out_max - out_min) / (in_max - in_min) + out_min;
}