// Complete Instructions: https://RandomNerdTutorials.com/esp32-digital-inputs-outputs-arduino/

// set pin numbers
const int voltagePin = 34;  // the number of the pushbutton pin
//const int ledPin =  5;    // the number of the LED pin
float analogState = 0;
// variable for storing the pushbutton status 
int voltageState = 0;

void setup() {
  Serial.begin(115200);  
  // initialize the pushbutton pin as an input
  pinMode(voltagePin, INPUT);
  // initialize the LED pin as an output
  //pinMode(ledPin, OUTPUT);
}

void loop() {
  // read the state of the pushbutton value
 voltageState = analogRead(voltagePin);
 analogState = 0.000805860806*voltageState;
 Serial.println("analogState");
 Serial.println("v");
  //Serial.println(buttonState);
  // check if the pushbutton is pressed.
  // if it is, the buttonState is HIGH
  //if (buttonState == HIGH) {
    //Serial.println("bright");
    // turn LED on
    //digitalWrite(ledPin, HIGH);
  //} else {
    // turn LED off
    //digitalWrite(ledPin, LOW);
    //Serial.println("dark");
  //}
}