// beep on certain period_ 
const int buzzer = 12;
const long onDuration = 5;// OFF time for LED
const long offDuration = 2000;// ON time for LED
int BUZState = HIGH; // initial state of LED

long rememberTime = 0; // this is used by the code
int PIRread = 0;
int PIRpin = 13;
int  PIRreadBJ = 0;
int maxNum = 6;
int i = 0;

int ledPin =  12;      // the number of the LED pin
int ledState = LOW;             // ledState used to set the LED
unsigned long previousMillis = 0;        // will store last time LED was updated
long OnTime = 5;           // milliseconds of on-time
long OffTime = 2000;          // milliseconds of off-time

void setup() {

  Serial.begin(9600);
  pinMode(buzzer, OUTPUT); // define buzzer as output
  digitalWrite(buzzer, BUZState); // set initial state
}

void loop() {
  PIRread = digitalRead(PIRpin);
  Serial.print("PIR =");
  Serial.println(digitalRead(PIRpin));

  if (PIRread == HIGH)
  {
    PIRreadBJ = 1;
  }
  if (PIRreadBJ == 1) {
    for (int i = 0; i <= maxNum; i++)
    {
      BUZloopO(); //
    }
    if (i == maxNum)
    {
      digitalWrite(ledPin, LOW);
    }
  }
}

void BUZloopO() {
  unsigned long currentMillis = millis();
  if ((BUZState == HIGH) && (currentMillis - previousMillis >= OnTime))
  {
    BUZState = LOW;  // Turn it off
    previousMillis = currentMillis;  // Remember the time
    digitalWrite(ledPin, BUZState);  // Update the actual LED
  }
  else if ((BUZState == LOW) && (currentMillis - previousMillis >= OffTime))
  {
    BUZState = HIGH;  // turn it on
    previousMillis = currentMillis;   // Remember the time
    digitalWrite(ledPin, BUZState);   // Update the actual LED
  }
}