const int sensorPin = A0; // Analog pin for sensor connection (if not using I2C)
const float BETA = 3950; // Beta coefficient, adjust according to sensor datasheet
float Vcc = 5.0; // Supply voltage, adjust if different

void setup() {
  Serial.begin(115200); // Set serial communication speed

  
  // Set sensor pin as input (if not using I2C)
  pinMode(sensorPin, INPUT);
}

void loop() {
  
  // Read analog voltage from sensor (if not using I2C)
  int sensorValue = analogRead(sensorPin);

  // Calculate temperature in Celsius
  float voltage = sensorValue * (Vcc / 1023.0);
  float resistance = Vcc / voltage - 10.0; // Assuming 10k pull-up resistor
  float temperature = 1 / (log(resistance / 10000.0) / BETA + 1.0 / 298.15) - 273.15;

  // Print temperature to serial monitor
  Serial.print("Temperature: ");
  Serial.print(temperature);
  Serial.println(" °C");

  // Display temperature on Wokwi (if desired)
  // ... (code to send temperature data to Wokwi)

  delay(1000); // Adjust delay as needed
}