/*
  Uno with Scope https://github.com/Dlloydev/Wokwi-Chip-Scope
        and https://github.com/Dlloydev/Wokwi-Chip-PWM
        and https://github.com/drf5n/Wokwi-Chip-FrequencyCounter

  Wokwi Uno https://wokwi.com/projects/390819301187622913
  Wokwi Mega: https://wokwi.com/projects/390819455604080641
  Wokwi ESP32S3 https://wokwi.com/projects/404720144387009537

  See also https://wokwi.com/projects/359331973918199809

*/

/*

  Running Blink.ino
  Turns an LED on for one second, then off for one second, repeatedly.

  Most Arduinos have an on-board LED you can control. On the UNO, MEGA and ZERO
  it is attached to digital pin 13, on MKR1000 on pin 6. LED_BUILTIN is set to
  the correct LED pin independent of which board is used.
  If you want to know what pin the on-board LED is connected to on your Arduino
  model, check the Technical Specs of your board at:
  https://docs.arduino.cc/hardware/

  modified 8 May 2014
  by Scott Fitzgerald
  modified 2 Sep 2016
  by Arturo Guadalupi
  modified 8 Sep 2016
  by Colby Newman

  This example code is in the public domain.

  https://docs.arduino.cc/built-in-examples/basics/Blink/
*/

// the setup function runs once when you press reset or power the board
void setup() {
  // initialize digital pin LED_BUILTIN as an output.
  pinMode(LED_BUILTIN, OUTPUT);
}

// the loop function runs over and over again forever
void loop() {
  digitalWrite(LED_BUILTIN, HIGH);  // turn the LED on (HIGH is the voltage level)
  delay(1000);                      // wait for a second
  digitalWrite(LED_BUILTIN, LOW);   // turn the LED off by making the voltage LOW
  delay(1000);                      // wait for a second
}
ScopeBreakout
Loading chip...chip-pwm
Loading chip...chip-freq
Wokwi UnoScope https://wokwi.com/projects/390819301187622913
cnt/meas
en/!dis