// Define the analog pin that connects to the resistor network
#define ANALOG_PIN A0

// Define the threshold values for each button
// These values depend on the resistor values and the analog reference voltage
// You may need to adjust them according to your circuit
#define BUTTON_1 50
#define BUTTON_2 150
#define BUTTON_3 250
#define BUTTON_4 350
#define BUTTON_5 450

// Define the functions to perform for each button
void button1Function() {
  // Do something when button 1 is pressed
  Serial.println("Button 1 pressed");
}

void button2Function() {
  // Do something when button 2 is pressed
  Serial.println("Button 2 pressed");
}

void button3Function() {
  // Do something when button 3 is pressed
  Serial.println("Button 3 pressed");
}

void button4Function() {
  // Do something when button 4 is pressed
  Serial.println("Button 4 pressed");
}

void button5Function() {
  // Do something when button 5 is pressed
  Serial.println("Button 5 pressed");
}

void setup() {
  // Initialize serial communication
  Serial.begin(9600);
  // Set the analog reference voltage to 5V
  analogReference(DEFAULT);
}

void loop() {
  // Read the analog value from the pin
  int value = analogRead(ANALOG_PIN);
  // Compare the value with the thresholds and call the corresponding function
  if (value < BUTTON_1) {
    button1Function();
  } else if (value < BUTTON_2) {
    button2Function();
  } else if (value < BUTTON_3) {
    button3Function();
  } else if (value < BUTTON_4) {
    button4Function();
  } else if (value < BUTTON_5) {
    button5Function();
  }
  // Wait for a short delay to avoid bouncing
  delay(100);
}