#include <Servo.h>

// Define slide potentiometer and servo motor pins
const int slidePotPin = A0; // Slide potentiometer connected to analog pin A0
const int servoPin = 9; // Servo motor connected to digital pin 9

Servo servo; // Create a servo object

void setup() {
  Serial.begin(9600); // Initialize serial communication
  servo.attach(servoPin); // Attach the servo to its pin
}

void loop() {
  int slidePotValue = analogRead(slidePotPin); // Read analog value from slide potentiometer

  int servoAngle = map(slidePotValue, 0, 1023, 0, 180); // Map potentiometer value to servo angle range

  servo.write(servoAngle); // Set servo position based on potentiometer value

  Serial.print("Slide Potentiometer Value: ");
  Serial.println(slidePotValue); // Print slide potentiometer value to serial monitor

  Serial.print("Servo Angle: ");
  Serial.println(servoAngle); // Print servo angle to serial monitor

  delay(1000); // Delay for stability
}