class Flasher
{
	// Class Member Variables
	// These are initialized at startup
	int ledPin;      // the number of the LED pin
	long OnTime;     // milliseconds of on-time
	long OffTime;    // milliseconds of off-time

	// These maintain the current state
	int ledState;             		// ledState used to set the LED
	unsigned long previousMillis;  	// will store last time LED was updated

  // Constructor - creates a Flasher 
  // and initializes the member variables and state
  public:
  Flasher(int pin, long on, long off)
  {
	ledPin = pin;
	pinMode(ledPin, OUTPUT);     
	  
	OnTime = on;
	OffTime = off;
	
	ledState = LOW; 
	previousMillis = 0;
  }

  void Update()
  {
    // check to see if it's time to change the state of the LED
    unsigned long currentMillis = millis();
     
    if((ledState == HIGH) && (currentMillis - previousMillis >= OnTime))
    {
    	ledState = LOW;  // Turn it off
      previousMillis = currentMillis;  // Remember the time
      digitalWrite(ledPin, ledState);  // Update the actual LED
    }
    else if ((ledState == LOW) && (currentMillis - previousMillis >= OffTime))
    {
      ledState = HIGH;  // turn it on
      previousMillis = currentMillis;   // Remember the time
      digitalWrite(ledPin, ledState);	  // Update the actual LED
    }
  }
};


Flasher led1(12, 100, 400);
Flasher led2(13, 200, 200);
Flasher led3(11, 300, 300);
Flasher led4(10, 400, 200);
Flasher led5(9,  500, 300);
void setup()
{
}

void loop()
{
	led1.Update();
	led2.Update();
    led3.Update();
    led4.Update();
    led5.Update();
  
}