#define BLYNK_TEMPLATE_ID "TMPL3adQ3Uxtw"
#define BLYNK_TEMPLATE_NAME "LED SWITCH CONTROL"
#define BLYNK_AUTH_TOKEN "g9pUPhkruune544MQUN0vkuT6NEZqaRl"
#define BLYNK_TEMPLATE_NAME "BUZZER"
#define BLYNK_AUTH_TOKEN "l8TxK9sxQ7kA247UnJ3CfPwM5RRPapmi"

#define BLYNK_PRINT Serial
//unsigned int value = 0;
#include <WiFi.h>
#include <WiFiClient.h>
#include <BlynkSimpleEsp32.h>
// Your WiFi credentials.
char ssid[] = "Wokwi-GUEST";
char pass[] = "";
BlynkTimer timer;

BLYNK_WRITE(V0)
{
Serial.println("Inside Blynk Write");
if(param.asInt() == 1)
{
Serial.println("Blynk Write: Pin Value is 1");

digitalWrite(2, HIGH);
  tone(2,262,250);

 
}

else
{
Serial.println("Blynk Write: Pin Value is 0");
digitalWrite(2, LOW);
  tone(2,262,250);

}
}


BLYNK_CONNECTED()
{
Blynk.syncVirtual(V0);
Serial.println("Inside Blynk Connected");
}
// This function sends Arduino's uptime every second to Virtual Pin 2.
void myTimerEvent()
{

Blynk.virtualWrite(V0, millis() / 1000);
}
void setup()
{
// Debug console
pinMode(4,OUTPUT);
pinMode(2, OUTPUT);
Serial.begin(115200);
Serial.println("Serial Prints Starts...");
Blynk.begin(BLYNK_AUTH_TOKEN, ssid, pass);

}
void loop()
{
   digitalWrite(2, HIGH);
  
 
  
Blynk.run();

}