const int boton=22;
const int botonB=17;


#include <SPI.h>
#include <Wire.h>
#include < Adafruit_GFX.h>
#include <Adafruit_SSD1306.h>

#define SCREEN_WIDTH 128
#define SCREEN_HEIGHT 64

#define OLED_RESET     -1 // Reset pin # (or -1 if sharing Arduino reset pin)
#define SCREEN_ADDRESS 0x3C ///< See datasheet for Address; 0x3D for 128x64, 0x3C for 128x32
Adafruit_SSD1306 display(SCREEN_WIDTH, SCREEN_HEIGHT, &Wire, OLED_RESET);


void setup() {
  Serial.begin(9600);

  if(!display.begin(SSD1306_SWITCHCAPVCC, SCREEN_ADDRESS)) {
    Serial.println(F("SSD1306 allocation failed"));
    for(;;); // Don't proceed, loop forever
  }
pinMode(boton, INPUT_PULLUP);
pinMode(botonB, INPUT_PULLUP);
  display.println("Hola humano");
  display.display();
  display.setTextSize(1);
  display.setTextColor(WHITE);
  display.clearDisplay();



}

void loop() { 
  display.println("Hola humano");
 PREGUNTAR:;
  if(digitalRead(boton)==LOW) 
  {
  display.setCursor(20,35);
  display.println(" humano ");
  display.display();
   display.clearDisplay();
  }
  
  if(digitalRead(botonB)==LOW) 
  {
  display.setCursor(20,35);
  display.println(" lolxd ");
  display.display();
  display.clearDisplay();

  }
  goto PREGUNTAR;
}