#define BLYNK_TEMPLATE_ID "TMPL6R0zB9Iiq"
#define BLYNK_TEMPLATE_NAME "Nanda Ausil Jannati"
#define BLYNK_AUTH_TOKEN "RyG6XpuPJBuBgm4u0GS9QIc1q9l4jeno"
#define BLYNK_PRINT Serial
#define BLYNK_WRITE

#include <WiFi.h>
#include <WiFiClient.h>
#include <BlynkSimpleEsp32.h>
#include <DHTesp.h>

//set ssid wifi
char ssid[] = "Wokwi-GUEST";
char passw[] = "";

//untuk menghidupkan lampu dan ac
BLYNK_WRITE(V4) {
  int tombol = param.asInt();
  if (tombol == 1) {
    Blynk.virtualWrite(V2, HIGH);
    Serial.println("AC = ON");
    Blynk.virtualWrite(V5, HIGH);
    digitalWrite(33, HIGH);
  }
  else {
    Blynk.virtualWrite(V2, LOW);
    Serial.println("AC = OFF");
    Blynk.virtualWrite(V5, LOW);
    digitalWrite(33, LOW);
  }
}

const int DHT_PIN = 14;
DHTesp dhtSensor;
float temperature = 0;


//---------end kondisi tombol----------
void setup() {
  // Definisikan setiap pin lampu dan sensor
  Serial.begin(115200); 
  Blynk.begin(BLYNK_AUTH_TOKEN,ssid,passw);
  dhtSensor.setup(DHT_PIN, DHTesp::DHT22);
  pinMode(32, OUTPUT);
  pinMode(33, OUTPUT);
}

void loop() {
  Blynk.run();
  //membaca suhu dan kelembaban
  TempAndHumidity  data = dhtSensor.getTempAndHumidity();
  temperature=data.temperature;
  Blynk.virtualWrite(V1, temperature);

  //menampilkan data suhu dan kelembaban
  Serial.print("Temp : ");
  Serial.print(temperature);
  Serial.println(" C");

  //menghidupkan lampu dengan suhu 
  if(temperature>25)
  {
    digitalWrite(32, HIGH);
    Blynk.virtualWrite(V3, HIGH);
  }
  else 
  {
    digitalWrite(32, LOW);
    Blynk.virtualWrite(V3, LOW);
  }
  delay(100);
}