#include <MD_Parola.h>
#include <MD_MAX72xx.h>
#include <SPI.h>

#define CLK_PIN 13  // CLK pin of the dot matrix display connected to Arduino's pin 13 (SCK)
#define DIN_PIN 11  // DIN pin of the dot matrix display connected to Arduino's pin 11 (MOSI)
#define CS_PIN 5   // CS pin of the dot matrix display connected to Arduino's pin 3

#define Hardware_type MD_MAX72XX::FC16_HW
#define max_dev 4
MD_Parola Display = MD_Parola(Hardware_type, CS_PIN, max_dev);

void setup() {
  // put your setup code here, to run once:
  SPI.begin();  // Initialize SPI communication
  Display.begin();
  Display.setIntensity(0);
  Display.displayClear();
  Display.displayText("CUTIEPIE", PA_CENTER, 100, 0, PA_SCROLL_LEFT, PA_SCROLL_LEFT);
}

void loop() {
  // put your main code here, to run repeatedly:
  // Display.setTextAlignment(PA_LEFT);
  // Display.print("H");
  // delay(200);
  // Display.setTextAlignment(PA_CENTER);
  // Display.print("H");
  // delay(2000);
  Display.setTextAlignment(PA_LEFT);
  Display.print("Hello");
  // delay(2000);
  // if (Display.displayAnimate()) {
  //   Display.displayReset();
  // }
}