//Includes the Arduino Stepper Library
/*#include <Stepper.h>

// Defines the number of steps per rotation
const int stepsPerRevolution = 2038;

// Creates an instance of stepper class
// Pins entered in sequence IN1-IN3-IN2-IN4 for proper step sequence
Stepper myStepper = Stepper(stepsPerRevolution, 8, 10, 9, 11);

void setup() {
    // Nothing to do (Stepper Library sets pins as outputs)
}

void loop() {
	// Rotate CW slowly at 5 RPM
	myStepper.setSpeed(5);
	myStepper.step(stepsPerRevolution);
	delay(1000);
	
	// Roe CCW quickly at 10 RPM
	myStepper.setSpeed(10);
	myStepper.step(-stepsPerRevolution);
	delay(1000);
}*/

// Include the AccelStepper Library
#include <AccelStepper.h>

// Define step constant
#define MotorInterfaceType 4

// Creates an instance
// Pins entered in sequence IN1-IN3-IN2-IN4 for proper step sequence
AccelStepper myStepper(MotorInterfaceType, 8, 10, 9, 11);

void setup() {
	// set the maximum speed, acceleration factor,
	// initial speed and the target position
	myStepper.setMaxSpeed(1000.0);
	myStepper.setAcceleration(50.0);
	myStepper.setSpeed(200);
	myStepper.moveTo(2038);
}

void loop() {
	// Change direction once the motor reaches target position
	if (myStepper.distanceToGo() == 0) 
		myStepper.moveTo(-myStepper.currentPosition());

	// Move the motor one step
	myStepper.run();
}