#define BLYNK_PRINT Serial

#define BLYNK_TEMPLATE_ID "TMPL3np-2UFsc"
#define BLYNK_TEMPLATE_NAME "SMART HOME BY FAHAD KHAN"
#define BLYNK_AUTH_TOKEN "fCR0pWQaEQg0jr3E5WXgc9Fd1gapXwvI"
#include <WiFi.h>
#include <WiFiClient.h>
#include <BlynkSimpleEsp32.h>
char auth[] = BLYNK_AUTH_TOKEN;
char ssid[] = "Wokwi-GUEST";
char pass[] = "";
#define LED1 14  
#define LED2 12
// V1
#define LED1 13
// V2

int SW_State_M = 0;
BLYNK_WRITE (V0)
{
  SW_State_M = param.asInt();
  if (SW_State_M == 1)
  {
    digitalWrite(LED1, HIGH);
    Serial.println("LED ON");
    Blynk.virtualWrite(V1, HIGH);
  }
  else
  {
    digitalWrite(LED1, LOW);
    Serial.println("LED OFF");
    Blynk.virtualWrite(V1, LOW);
  }
}
void setup()
{
  pinMode(LED1, OUTPUT);
  Serial.begin(9600);
  Blynk.begin(auth, ssid, pass);
}

void setup() {
  pinMode(14, OUTPUT);
  pinMode(12, OUTPUT);
  pinMode(13, OUTPUT);

  Serial.begin(115200);
  Serial.println("Hello, ESP32!");

  // RELAY NORMALLY OPEN- NO - 
}

void loop() {
  // put your main code here, to run repeatedly:

  digitalWrite(14, HIGH);
  Serial.println("RELAY ON ");
  delay(3000); 
  digitalWrite(14, LOW);
  Serial.println("RELAY OFF ");
  delay(3000); 


}

void loop()
{
  Blynk.run();
}