//Wokwi Serial terminal simulation - Wokwi Arduino Simulator


void setup()
{
  Serial.begin(9600);
  Serial.println("Welcome to the Serial Monitor!");
  Serial.println("---------------------------------");
}

void loop()
{
  if (Serial.available()) {             //Syntaxis  N#(up to 16-bit) and then string e.g. 1024A1 N#=1024 & string=A1
   int value = Serial.parseInt();
   String Commant = Serial.readStringUntil('\n');
    Commant.trim();
    Serial.println(Commant);
    Serial.println(value);
    if (Commant == "A"){
      Serial.print("Commant = "); Serial.println(Commant);
      Serial.print("Value = "); Serial.println(value);
      Serial.println("Initialize the pressure values");
      Serial.println("---------------------------------");
    }
        if (Commant == "M"){
      Serial.print("Commant = "); Serial.println(Commant);
      Serial.print("Value = "); Serial.println(value);
      Serial.println("Motor set mode");
      Serial.println("---------------------------------");
    }
       if (Commant == "F"){
      Serial.print("Commant = "); Serial.println(Commant);
      Serial.print("Value = "); Serial.println(value);
      Serial.println("flow set mode");
      Serial.println("---------------------------------");
    }
     if (Commant == "X"){
      Serial.print("Commant = "); Serial.println(Commant);
      Serial.print("Value = "); Serial.println(value);
      Serial.println("M A L A K I A");
      Serial.println("---------------------------------");
    }
      
       }
}