const byte LEDVm  = 2;
const byte LEDVd  =3 ;
const byte LEDAm  =4 ;
const byte potenciometro1 = 28;
const byte potenciometro2 = 27;
const byte potenciometro3 = 26;
unsigned int valorpotenciometro1;
unsigned int valorpotenciometro2;
unsigned int valorpotenciometro3;

void setup() {
  pinMode(LEDVm, OUTPUT);
  pinMode(LEDVd, OUTPUT);
  pinMode(LEDAm, OUTPUT);
  pinMode(potenciometro1,INPUT);
  pinMode(potenciometro2,INPUT);
  pinMode(potenciometro3,INPUT);
  // put your setup code here, to run once:
  Serial1.begin(115200);
  Serial1.println("Hello, Raspberry Pi Pico!");
}

void loop() {
  valorpotenciometro1 = analogRead(potenciometro1);
  valorpotenciometro2 = analogRead(potenciometro2);
  valorpotenciometro3 = analogRead(potenciometro3);
  analogWrite(LEDVm,byte (valorpotenciometro1 /4));
  analogWrite(LEDVd,byte (valorpotenciometro2 /4));
  analogWrite(LEDAm,byte (valorpotenciometro3 /4));
  // put your main code here, to run repeatedly:
  delay(1); // this speeds up the simulation
}