#define BLYNK_PRINT Serial

#define BLYNK_TEMPLATE_ID "TMPL3np-2UFsc"
#define BLYNK_TEMPLATE_NAME "SMART HOME BY FAHAD KHAN"
#define BLYNK_AUTH_TOKEN "fCR0pWQaEQg0jr3E5WXgc9Fd1gapXwvI"
#include <WiFi.h>
#include <WiFiClient.h>
#include <BlynkSimpleEsp32.h>

char auth[] = BLYNK_AUTH_TOKEN;
char ssid[] = "Wokwi-GUEST";
char pass[] = "";

#define LED1 14  
#define LED2 12
#define LED3 13 

int SW_State_M = 0;

BLYNK_WRITE(V0)
{
  SW_State_M = param.asInt();
  if (SW_State_M == 1)
  {
    digitalWrite(LED1, HIGH);
    Serial.println("LED ON");
    Blynk.virtualWrite(V0, HIGH);
  }
  else
  {
    digitalWrite(LED1, LOW);
    Serial.println("LED OFF");
    Blynk.virtualWrite(V0, LOW);
  }
}

BLYNK_WRITE(V1)
{
  SW_State_M = param.asInt();
  if (SW_State_M == 1)
  {
    digitalWrite(LED2, HIGH);
    Serial.println("LED ON");
    Blynk.virtualWrite(V1, HIGH);
  }
  else
  {
    digitalWrite(LED2, LOW);
    Serial.println("LED OFF");
    Blynk.virtualWrite(V1, LOW);
  }
}

BLYNK_WRITE(V2)
{
  SW_State_M = param.asInt();
  if (SW_State_M == 1)
  {
    digitalWrite(LED3, HIGH);
    Serial.println("LED ON");
    Blynk.virtualWrite(V2, HIGH);
  }
  else
  {
    digitalWrite(LED3, LOW);
    Serial.println("LED OFF");
    Blynk.virtualWrite(V2, LOW);
  }
}

void setup()
{
  pinMode(LED1, OUTPUT);
  pinMode(LED2, OUTPUT);
  pinMode(LED3, OUTPUT); // Set LED3 pin as output
  Serial.begin(9600);
  Blynk.begin(auth, ssid, pass);
}

void loop()
{
  Blynk.run();
}