#include <IRremote.h>
int RECV_PIN = 11;
int LED1 = 2;
int LED2 = 3;
int LED3 = 4;
int LED4 = 5;
int LED5 = 6;
int LED6 = 7;

bool LEDState[6]{LOW,LOW,LOW,LOW,LOW,LOW};

IRrecv irrecv(RECV_PIN);
decode_results results;

 void translateIR()
{
  // Takes command based on IR code received
  switch (irrecv.decodedIRData.command) {
    
    case 48:
      //lcdPrint("num: 1");
      digitalWrite(LED1, LEDState[0]=!LEDState[0]);
      break;
    case 24:
      //lcdPrint("num: 2");
      digitalWrite(LED2, LEDState[1]=!LEDState[1]);
      break;
    case 122:
      //lcdPrint("num: 3");
      digitalWrite(LED3, LEDState[2]=!LEDState[2]);
      break;
    case 16:
      //lcdPrint("num: 4");
      digitalWrite(LED4, LEDState[3]=!LEDState[3]);
      break;
    case 56:
      //lcdPrint("num: 5");
      digitalWrite(LED5, LEDState[4]=!LEDState[4]);
      break;
    case 90:
      //lcdPrint("num: 6");
      digitalWrite(LED6, LEDState[5]=!LEDState[5]);
      break;
    default:
      digitalWrite(LED1, LOW);
      digitalWrite(LED2, LOW);
      digitalWrite(LED3, LOW);
      digitalWrite(LED4, LOW);
      digitalWrite(LED5, LOW);
      digitalWrite(LED6, LOW);
  }
}
  
void setup()
{
 pinMode(RECV_PIN, INPUT); 
 pinMode(LED1, OUTPUT);
 pinMode(LED2, OUTPUT);
 pinMode(LED3, OUTPUT);
 pinMode(LED4, OUTPUT);
 pinMode(LED5, OUTPUT);
 pinMode(LED6, OUTPUT); 
 pinMode(13, OUTPUT);
 Serial.begin(9600);
 irrecv.enableIRIn(); // Start the receiver
}

int on = 0;
unsigned long last = millis();
void loop() 
{
 if (irrecv.decode()) {
    translateIR();
    irrecv.resume();  // Receive the next value
  }

 if (irrecv.decode(&results)) 
 {
 // If it's been at least 1/4 second since the last
 // IR received, toggle the relay
 if (millis() - last > 250) 
 {
 on = !on;
 //digitalWrite(8, on ? HIGH : LOW);
 //digitalWrite(13, on ? HIGH : LOW);

irrecv.resume(); // Receive the next value
 }
 }
 }