#include <IRremote.h>

int led_pin=3;
int receiver_pin=2;
int button_value=0;

IRrecv receiver(receiver_pin);

void setup() {
  // put your setup code here, to run once:
  Serial.begin(9600);
  receiver.enableIRIn();
}

void loop() {
  // put your main code here, to run repeatedly:
  if (receiver.decode())
  {
    translateIR();
    receiver.resume();
  }

}

int translateIR()
{
  button_value=receiver.decodedIRData.command;
  Serial.println(button_value);

  if (button_value == 162)
  {
    Serial.println("POWER");
    digitalWrite(led_pin, LOW);
  }

  if (button_value == 226)
  {
    Serial.println("MENU");
    Serial.println("Press TEST to turn ON the LED");
    Serial.println("Press POWER to turn OFF the LED");
    Serial.println("Press ONE/1 to blink the LED");
  }

  if (button_value == 34)
  {
    Serial.println("TEST");
    digitalWrite(led_pin, HIGH);
  }

  if (button_value == 48)
  {
    Serial.println("ONE");
    digitalWrite(led_pin, HIGH);
    delay(300);
    digitalWrite(led_pin, LOW);
    delay(300);
    digitalWrite(led_pin, HIGH);
    delay(300);
    digitalWrite(led_pin, LOW);
    delay(300);
  }
}