#include <Adafruit_SSD1306.h>
#include <Wire.h>
#include <Adafruit_GFX.h>

int address = 60; //0x3C; //means 12 (C) plus 3 16s or 48
                    //12 + 48 is 60. 
int r_button = 2;
int l_button = 3;
int screen_width = 128;
int screen_height = 64;

//declaring my new lcd and naming it "screen
Adafruit_SSD1306 screen(screen_width,screen_height,&Wire, -1);
//(pixels wide, pixels tall, wire library, -1 is for the uno board reset pin)


void setup() {
 pinMode(r_button,INPUT); 
 pinMode(l_button,INPUT); 
 
  // put your setup code here, to run once:
screen.begin(SSD1306_SWITCHCAPVCC,address);
screen.clearDisplay();//clears everything off display
Serial.begin(9600);
}
int width = 20;
int height = 10;
void loop() {
  if (digitalRead(3) == 1) {
 L();
 }
 if (digitalRead(2) == 1) {
 R();
 }
 if (digitalRead(4) == 1) {
 RL();
 }
}
void R() {
screen.clearDisplay();
screen.fillRect(64,0,64,64,1);
screen.drawLine(76,12,116,12,0);
screen.drawLine(76,12,76,52,0);
screen.drawLine(76,52,116,52,0);
screen.display();
}
void L() {
screen.clearDisplay();
screen.fillRect(0,0,64,64,1);
screen.drawLine(12,12,12,52,0);
screen.drawLine(12,32,52,32,0);
screen.drawLine(52,52,52,12,0);
screen.display();
}
void RL() {
screen.clearDisplay();
screen.fillRect(0,0,64,64,1);
screen.drawLine(12,12,12,52,0);
screen.drawLine(12,32,52,32,0);
screen.drawLine(52,52,52,12,0);
screen.fillRect(64,0,64,64,1);
screen.drawLine(76,12,116,12,0);
screen.drawLine(76,12,76,52,0);
screen.drawLine(76,52,116,52,0);
screen.display();
}