#define BLYNK_TEMPLATE_ID "TMPL3tZQjBsoX"
//#define BLYNK_TEMPLATE_NAME "Quickstart Template"//
//#define BLYNK_AUTH_TOKEN "FQNHLNpdqtKfBXncrW-ozG5wgyiuDxjn"//
#define BLYNK_TEMPLATE_NAME "LED ON OFF"
#define BLYNK_AUTH_TOKEN "0wvLkZ-R9NthTz-E7I7jMBQSXrgIQNan"



//#define BLYNK_TEMPLATE_ID "TMPL3tZQjBsoX"
//#define BLYNK_TEMPLATE_NAME "Quickstart Template"

//#define BLYNK_AUTH_TOKEN "psNTz7Ly3CBsLnYPKfpTiZj4ya22LyQB"
#define BLYNK_PRINT Serial
#include <WiFi.h>
#include <BlynkSimpleEsp32.h>
char ssid[] = "Wokwi-GUEST";
char pass[] = "";
BlynkTimer timer;
BLYNK_WRITE(V0)
{
  Serial.println("Inside Blynk Write");
  while(1)
  {
    if(param.asInt() == 1)
    {
      Serial.println("Blynk write: Pin Value is 1");
      digitalWrite(2, HIGH);
      delay(5000);
      digitalWrite(2, LOW);
      delay(3000);
    }
    else{
      Serial.println("Blynk Write: Pin value is 0");
      digitalWrite(2, LOW);
    }
  }
}


void setup() {
  // put your setup code here, to run once:
  pinMode(2, OUTPUT);
  Serial.begin(115200);
  Serial.println("SERIAL PRINTS STARTS.....");
  Blynk.begin(BLYNK_AUTH_TOKEN,ssid,pass);

}

void loop() {
  // put your main code here, to run repeatedly:
  Blynk.run();
  //delay(10); // this speeds up the simulation
}