int switchstate;
int relaystate=LOW;
void setup() {
Serial.begin(9600); // Must be 9600
Serial.println("setup");
pinMode(12, OUTPUT);//soft starter
pinMode(11, OUTPUT);
pinMode(13, INPUT_PULLUP);
}

void loop() {
  switchstate = digitalRead(13);
  if (switchstate == LOW && relaystate ==LOW){
    digitalWrite(12, HIGH);
    Serial.println("turned on relay1");
    delay(2000);
    digitalWrite(11, HIGH);
    Serial.println("turned on relay2");
    //digitalWrite(12, LOW);
    relaystate = HIGH;
  }
  else if (switchstate == HIGH && relaystate == HIGH){
    digitalWrite(12, LOW);
    Serial.println("turned off relay1");
    digitalWrite(11, LOW);
    Serial.println("turned off relay2");
    relaystate = LOW;
  }
  
  // put your main code here, to run repeatedly:

}