int Xpin=A0; //Horz
int Ypin=A1; // Vert
int Spin=2; //Sel
int Xval;
int Yval; 
int Sval; //selval
int dt=300;
void setup() {
  // put your setup code here, to run once:
  Serial.begin(9600);
  pinMode(Xpin,INPUT);
  pinMode(Ypin, INPUT);
  pinMode(Spin, INPUT);
  digitalWrite(Spin, HIGH);
}

void loop() {
  // put your main code here, to run repeatedly:
  Xval=analogRead(Xpin);
  Yval=analogRead(Ypin);
  Sval=digitalRead(Spin);
  delay(dt);
  Serial.print("X Value =");
  Serial.println(Xval);
  Serial.print("Y Value = ");
  Serial.println(Yval);
  Serial.print("Switch State is ");
  Serial.println(Sval);
}