#include <Wire.h>

#define BMP585_I2C_ADDRESS 0x76 // Adjust if necessary

float readTemperature() {
  // Implement I2C communication to read temperature from BMP585
  // Example pseudocode:
  Wire.beginTransmission(BMP585_I2C_ADDRESS);
  // Write commands to initiate temperature reading
  Wire.endTransmission();
  
  Wire.requestFrom(BMP585_I2C_ADDRESS, 2); // Request 2 bytes for temperature
  int rawTemp = (Wire.read() << 8) | Wire.read();
  
  float temperature = rawTemp / 100.0; // Adjust based on sensor's data sheet
  return temperature;
}

float readPressure() {
  // Implement I2C communication to read pressure from BMP585
  // Example pseudocode:
  Wire.beginTransmission(BMP585_I2C_ADDRESS);
  // Write commands to initiate pressure reading
  Wire.endTransmission();
  
  Wire.requestFrom(BMP585_I2C_ADDRESS, 3); // Request 3 bytes for pressure
  int rawPressure = (Wire.read() << 16) | (Wire.read() << 8) | Wire.read();
  
  float pressure = rawPressure / 100.0; // Adjust based on sensor's data sheet
  return pressure;
}


void setup() {
  Serial.begin(115200); // Initialize serial communication at 115200 baud rate
  Wire.begin();         // Initialize I2C communication

  Serial.println("BMP585 Sensor Test");
}

void loop() {
  float temperature = readTemperature();
  float pressure = readPressure();

  // Print the temperature and pressure values
  Serial.print("Temperature: ");
  Serial.print(temperature);
  Serial.println(" °C");

  Serial.print("Pressure: ");
  Serial.print(pressure);
  Serial.println(" hPa");

  delay(1000); // Wait for a second before repeating
}