void setup() {
  // put your setup code here, to run once:
  Serial.begin(115200);
  Serial.println("Hello, ESP32-S3!");

   printf("ESP32 Partition table:\n\n");

  printf("| Type | Sub |  Offset  |   Size   |       Label      |\n");
  printf("| ---- | --- | -------- | -------- | ---------------- |\n");
  
  esp_partition_iterator_t pi = esp_partition_find(ESP_PARTITION_TYPE_ANY, ESP_PARTITION_SUBTYPE_ANY, NULL);
  if (pi != NULL) {
    do {
      const esp_partition_t* p = esp_partition_get(pi);
      printf("|  %02x  | %02x  | 0x%06X | 0x%06X | %-16s |\r\n", 
        p->type, p->subtype, p->address, p->size, p->label);
    } while (pi = (esp_partition_next(pi)));
  }

  
}

void loop() {
  // put your main code here, to run repeatedly:
  delay(10); // this speeds up the simulation
}