// test a stepper motor with a Pololu A4988 driver board, onboard led will flash at each step
// this version uses delay() to manage timing
byte directionPin = 8;
byte stepPin = 9;
int numberOfSteps = 200;
byte ledPin = 13;
int pulseWidthMicros = 2;  // microsecondo
int millisbetweenSteps = 1; // milliseconds - or try 100 for slower steps
int statostart;
void setup() { 
  Serial.begin(9600);
  Serial.println("Starting StepperTest");
  digitalWrite(ledPin, LOW);
  pinMode(directionPin, OUTPUT);
  pinMode(stepPin, OUTPUT);
  pinMode(ledPin, OUTPUT);
  pinMode(2, INPUT);
}

void loop() { 

    digitalWrite(directionPin, HIGH);
    for(int n = 0; n < numberOfSteps; n++) {
     digitalWrite(stepPin, HIGH);
     delayMicroseconds(pulseWidthMicros); 
     digitalWrite(stepPin, LOW);
     delay(millisbetweenSteps);
   
  }

}