#define BLYNK_TEMPLATE_ID "TMPL3Wwth2npN"
#define BLYNK_TEMPLATE_NAME "LCD 5"
#define BLYNK_AUTH_TOKEN "uZtMO37ldLlBexH7S0ivwFWqmgoHdNLc"

#define BLYNK_PRINT Serial
unsigned int value = 0;

#include <WiFi.h>
#include <WiFiClient.h>
#include <BlynkSimpleEsp32.h>

char ssid[] = "Wokwi-GUEST";
char pass[] = "";

BlynkTimer timer;

BLYNK_WRITE(V2)
{
  Serial.println("Inside Blynk Write");
  if(param.asInt() == 1)
  {
    Serial.println("Blynk Write: value is 0");
    digitalWrite(2, HIGH);
    digitalWrite(4, HIGH);
  }
  else
  {
    Serial.println("Blynk Write: value is 0");
    digitalWrite(2, LOW);
    digitalWrite(4, LOW);
  }
}
BLYNK_CONNECTED()
{
  Blynk.syncVirtual(V2);
  Serial.println("Inside Blynk Connected");
}

void myTimerEvent()
{
  Blynk.virtualWrite(V2,millis() / 1000);
}

void setup() 
{
  // put your setup code here, to run once:
  pinMode(2, OUTPUT);
  pinMode(4, OUTPUT);
  Serial.begin(11200);
  Serial.println("serial printer start...");

  Blynk.begin(BLYNK_AUTH_TOKEN, ssid, pass); 
}

void loop() 
{
  Blynk.run();
  // put your main code here, to run repeatedly:
  delay(10); // this speeds up the simulation
}