#define BLYNK_TEMPLATE_ID "TMPL6AAw6gLkS"
#define BLYNK_TEMPLATE_NAME "LED Kontrol"
#define BLYNK_AUTH_TOKEN "lDlDgnqJDer25ZYXhBQbGL8pXu9cx2Yw"

#include <WiFi.h>
#include <WiFiClient.h>
#include <BlynkSimpleEsp32.h>

char auth[] = "lDlDgnqJDer25ZYXhBQbGL8pXu9cx2Yw";
char ssid[] = "Wokwi-GUEST";
char pass[] = "";

BlynkTimer timer;

#define LED 5

int SW_state = 0; // Deklarasi variabel SW_state

BLYNK_WRITE(V0)
{
  SW_state = param.asInt(); // Menggunakan param.asInt() untuk mendapatkan nilai dari tombol Blynk
}

void setup() {
  // put your setup code here, to run once:
  Serial.begin(115200);
  Serial.println("Hello, ESP32!");
  pinMode(LED, OUTPUT);
  Blynk.begin(auth, ssid, pass);
}

void loop() {
  // put your main code here, to run repeatedly:
  Blynk.run();
  timer.run();
  if(SW_state == 1){
    digitalWrite(LED, HIGH);
    Blynk.virtualWrite(V0, HIGH);
  }
  else
  {
    digitalWrite(LED, LOW);
    Blynk.virtualWrite(V0, LOW);
  }
  delay(10); // this speeds up the simulation
}