// Button Example Two (active low)
//
// Button not pressed: signal is HIGH
// Button pressed    : signal is LOW
//
// The resistor keeps pin 4 high when the button
// is not pressed.
// The resistor is a pullup resistor.
//
// Button Example One: https://wokwi.com/projects/397990618860958721
// Button Example Two: https://wokwi.com/projects/397990611031240705
//
// The external resistor is optional, since
// also the internal pullup resistor is turned on.
//
// 16 May 2024, by Koepel, Public Domain.

const int buttonPin = 4;
int oldValue = HIGH; // default/idle value for pin 4 is high.

void setup() 
{
  Serial.begin(115200);
  Serial.println("Press the button.");

  // Initialize the pin for reading the button.
  pinMode(buttonPin, INPUT_PULLUP);
}

void loop() 
{
  // Read the value of pin 4.
  Serial.println(oldValue);
  int newValue = digitalRead(buttonPin);
 // Serial.println(newValue);

  // Check if the value was changed,
  // by comparing it with the previous value.
  if(newValue != oldValue)
  //Serial.println(newValue);
  {
    if(newValue == LOW)
    {
      Serial.println("The button is pressed.");
    }
    else
    {
      Serial.println("The button is released.");
    }
    // Remember the value for the next time.
    oldValue = newValue;
  }

  // Slow down the sketch.
  // Also for debouncing the button.
  delay(100);
}