#define VERT_PIN A0
#define HORZ_PIN A1
#define SRT_PIN 2
void setup() {
  // put your setup code here, to run once:
  Serial.begin(9600);
  pinMode(A0, INPUT);
  pinMode(A1, INPUT);
  pinMode(2, INPUT_PULLUP);
  pinMode(13, OUTPUT);
  pinMode(12, OUTPUT);
  pinMode(11, OUTPUT);
  pinMode(10, OUTPUT);
  digitalWrite(2,HIGH);

}

void loop() {
  // put your main code here, to run repeatedly:
  int vert = analogRead(VERT_PIN);
  int horz = analogRead(HORZ_PIN);
  int sw_data = digitalRead(SRT_PIN);
  Serial.print("vert =");
  Serial.print(vert);
  Serial.print("\t");
  Serial.print(" horz =");
  Serial.print(horz);
  Serial.print("\t");
  Serial.print("switch=");
  Serial.println(sw_data);

  if(vert ==0 && vert<300)
  {
   digitalWrite(13,HIGH);
  
  }
  if (vert == 1023)
  {
    digitalWrite(12, HIGH);
  } else
  {
   digitalWrite(13, LOW);
   digitalWrite(12, LOW);
  }

if(horz ==0 && horz<300)
  {
   digitalWrite(11, HIGH);
  }
  if (horz >= 1000)
  {
    digitalWrite(10, HIGH);
  } else
  {
   digitalWrite(11, LOW);
   digitalWrite(10, LOW);
  }
delay(10);
}