#include "ACS712.h"

//  Arduino UNO has 5.0 volt with a max ADC value of 1023 steps
//  ACS712 5A  uses 185 mV per A
//  ACS712 20A uses 100 mV per A
//  ACS712 30A uses  66 mV per A

ACS712  ACS(14, 3.3, 4095, 185);
//  ESP 32 example (might requires resistors to step down the logic voltage)
//  ACS712  ACS(25, 3.3, 4095, 185);

uint32_t start, stop;

void setup() {
  // put your setup code here, to run once:
  Serial.begin(115200);
  
  //  use simulation
  ACS.setADC(signal, 5, 1024);

  ACS.autoMidPoint();
  Serial.print("MidPoint: ");
  Serial.print(ACS.getMidPoint());
  Serial.print(". Noise mV: ");
  Serial.println(ACS.getNoisemV());
}

void loop() {
  delay(100);
  start = micros();
  //  int mA = ACS.mA_AC();
  int mA = ACS.mA_AC_sampling();
  stop = micros();
  Serial.print("mA: ");
  Serial.print(mA);
  Serial.print(". Form factor: ");
  Serial.print(ACS.getFormFactor());
  Serial.print("  time: ");
  Serial.println(stop - start);
  delay(5000);
}


//  simulated 60 Hz signal
uint16_t signal(uint8_t p)
{
  return 512 + 400 * sin((micros() % 1000000) * (TWO_PI * 60 / 1e6));
}