#include <OneWire.h>
#include <DallasTemperature.h>
#include <WiFi.h>
#include <ThingSpeak.h>

//define sound speed in cm/uS
#define SOUND_SPEED 0.034
#define CM_TO_INCH 0.393701


// Name of the router and password
const char* ssid = "Wokwi-GUEST";
const char* password = "";


unsigned long channelNumber =  2597469 ;
const char* WriteAPIKey = "PIBOU5XS3DEL8GG9";

WiFiClient client;

const int trigPin = 19;
const int echoPin = 18;

long duration;
float distanceCm;
float distanceInch;

// GPIO where the DS18B20 is connected to
const int oneWireBus = 12;     
// Setup a oneWire instance to communicate with any OneWire devices
OneWire oneWire(oneWireBus);
// Pass our oneWire reference to Dallas Temperature sensor 
DallasTemperature sensors(&oneWire);

void setup() {
  // put your setup code here, to run once:
  Serial.begin(115200);
  Serial.println("Hello, ESP32!");

  pinMode(trigPin, OUTPUT); // Sets the trigPin as an Output
  pinMode(echoPin, INPUT); // Sets the echoPin as an Input

  // Start wifi - 2 parameters (ssid & password)
 WiFi.begin(ssid, password);
  Serial.println("Connecting to WiFi");
  // Connection status
  while (WiFi.status() != WL_CONNECTED) {
    delay(500);
    Serial.print(".");
  }
  // Connection Info
  Serial.println("");
  Serial.println("WiFi connected!");
  Serial.print("IP Address: ");
  Serial.println(WiFi.localIP());

  ThingSpeak.begin(client);
  
}

void loop() {
  sensors.requestTemperatures(); 
  float temperatureC = sensors.getTempCByIndex(0);
  float temperatureF = sensors.getTempFByIndex(0);
  Serial.print(temperatureC);
  Serial.println("ºC");
  

  ThingSpeak.setField(1, temperatureC);

   // Clears the trigPin
  digitalWrite(trigPin, LOW);
  delayMicroseconds(2);
  // Sets the trigPin on HIGH state for 10 micro seconds
  digitalWrite(trigPin, HIGH);
  delayMicroseconds(10);
  digitalWrite(trigPin, LOW);
  
  // Reads the echoPin, returns the sound wave travel time in microseconds
  duration = pulseIn(echoPin, HIGH);
  
  // Calculate the distance
  distanceCm = duration * SOUND_SPEED/2;
  
  // Convert to inches
  distanceInch = distanceCm * CM_TO_INCH;
  
  // Prints the distance in the Serial Monitor
  Serial.print("Distance (cm): ");
  Serial.println(distanceCm);
  

  ThingSpeak.setField(2, distanceCm );

  int x = ThingSpeak.writeFields(channelNumber,  WriteAPIKey );

  if (x == 200){
    Serial.println("Success");
  }else{
    Serial.println("Failed: "+ String(x));
  }

  delay(1000);
}