#include <Servo.h>
Servo Xservo;
Servo Yservo;

int Xpin=A0;
int Ypin=A1;
int Spin=2;
int Xspin=9;
int Yspin=10;
int buzzPin=7;
int WVx;
int WVy;
int Xval;
int Yval;
int Sval;
int dt=200;
void setup() {
  // put your setup code here, to run once:
Serial.begin(9600);
pinMode(Xpin,INPUT);
pinMode(Ypin,INPUT);
pinMode(Spin,INPUT);
pinMode(Xspin,OUTPUT);
pinMode(Yspin,OUTPUT);
pinMode(buzzPin,OUTPUT);

Xservo.attach(Xspin);
Yservo.attach(Yspin);

digitalWrite(Spin,HIGH);
}


void loop() {
 Xval=analogRead(Xpin);
 WVx=(180./1023.)*Xval;
 Yval=analogRead(Ypin);
 WVy=(180./1023.)*Yval;
 Sval=digitalRead(Spin);

 Xservo.write(WVx);
 Yservo.write(WVy);

 if (Sval==0){
  digitalWrite(buzzPin, HIGH);
 }
 else {
  digitalWrite(buzzPin, LOW);
 }
 delay(dt);
 Serial.print("X Value = ");
 Serial.print(Xval);
 Serial.print(" Y Value = ");
 Serial.print(Yval);
 Serial.print(" Switch State is ");
 Serial.println(Sval);
}