#include <LiquidCrystal_I2C.h>

int PIRLED = 13;
int PIRPIN = 4;
int PIRSTATE = LOW;
int REDPIN = 5;
int GREENPIN = 6;
int BLUEPIN = 7;
int ECHOPIN = 2;
int TRIGPIN = 3;
int DISTLED = 12;
int val = 0;

LiquidCrystal_I2C LCD(0x27, 30, 4);

void resetLCD() {
  LCD.clear();
  LCD.setCursor(0, 0);
  LCD.print("Sita's House");
}

void setTempColor(int red, int green, int blue) {
  analogWrite(REDPIN, red);
  analogWrite(GREENPIN, green);
  analogWrite(BLUEPIN, blue);
}


void setup() {
  // put your setup code here, to run once:
  Serial.begin(9600);
  LCD.init();	// initialize the lcd
  LCD.backlight();
  LCD.print("Sita's House");

  pinMode(PIRLED, OUTPUT);  // declare LED as output;
  pinMode(PIRPIN, INPUT); // declare sensor as input

  pinMode(REDPIN, OUTPUT);
  pinMode(GREENPIN, OUTPUT);
  pinMode(BLUEPIN, OUTPUT); 

  pinMode(TRIGPIN, OUTPUT);
  pinMode(ECHOPIN, INPUT);
  pinMode(DISTLED, OUTPUT);
  
}

void loop() {

  // Temperature
  int analogValue = analogRead(A0);
  float celcius = 1 / (log(1 / (1023. / analogValue - 1)) / 3950 + 1.0 / 298.15) - 273.15;
  if (celcius >= 35.0) {
    setTempColor(255, 0, 0);
  }
  else if (celcius > 10.0 && celcius < 35.0) {
    setTempColor(0, 255, 0);
  }
  else if (celcius <= 10.0) {
    setTempColor(0, 0, 255);
  }
  LCD.setCursor(0, 1);
  LCD.print("Temp: ");
  LCD.print(celcius);
  LCD.print(" C   ");
  

  // Motion Detector
  val = digitalRead(PIRPIN);
  if (val == HIGH) {
    digitalWrite(PIRLED, HIGH);
    if (PIRSTATE == LOW) {
      LCD.clear();
      LCD.setCursor(0, 0);
      LCD.print("Motion detected!");
      PIRSTATE = HIGH;
    }
  }
  else {
    digitalWrite(PIRLED, LOW);
    if (PIRSTATE == HIGH) {
      LCD.clear();
      LCD.setCursor(0, 0);
      LCD.print("Motion ended!");
      delay(3000);
      resetLCD();
      PIRSTATE = LOW;
    }
  }

  // Distance Sensor

}