#include <IRremote.h>
int IR;
#define PIN_RECEIVER A0   // Signal Pin of IR receiver
IRrecv receiver(PIN_RECEIVER);

void setup() {
  // put your setup code here, to run once:
pinMode(2, OUTPUT);
digitalWrite(2, HIGH);
delay(1000);
digitalWrite(2, LOW);
delay(1000);

Serial.begin(9600);
  receiver.enableIRIn(); // Start the receiver

}

void loop() {
  // put your main code here, to run repeatedly:
if (receiver.decode()) {
    translateIR();
    receiver.resume();  // Receive the next value
  }
}
void translateIR()
{
  // Takes command based on IR code received
  switch (receiver.decodedIRData.command) {
    case 162:
      Serial.print("POWER");
      break;
    case 226:
      Serial.print("MENU");
      break;
    case 34:
      Serial.print("TEST");
      break;
    case 2:
      Serial.print("PLUS");
      break;
    case 194:
      Serial.print("BACK");
      break;
    case 224:
      Serial.print("PREV.");
      break;
    case 168:
      Serial.print("PLAY");
      break;
    case 144:
      Serial.print("NEXT");
      break;
    case 104:
      Serial.print("num: 0");
      break;
    case 152:
      Serial.print("MINUS");
      break;
    case 176:
      Serial.print("key: C");
      break;
    case 48:
      Serial.print("num: 1");
      break;
    case 24:
      Serial.print("num: 2");
      break;
    case 122:
      Serial.print("num: 3");
      break;
    case 16:
      Serial.print("num: 4");
      break;
    case 56:
      Serial.print("num: 5");
      break;
    case 90:
     Serial.print("num: 6");
      break;
    case 66:
      Serial.print("num: 7");
      break;
    case 74:
      Serial.print("num: 8");
      break;
    case 82:
      Serial.print("num: 9");
      break;
    default:
      Serial.println(receiver.decodedIRData.command);
      Serial.println("other button"); 
  }
}