#define btnPin 12

int btnPrevDebounce;
bool btnState, btnReading;
bool btnValue, btnPrevValue;
int count;

void setup() {
  Serial.begin(9600);
  // Set the button pin mode to pull up
  btnPrevDebounce = 0;
  btnState = btnReading = false;
  btnValue = btnPrevValue = false;
  count = 0;
}

void loop() {
  // Read the pin value

  if (btnReading != btnState) {
    btnPrevDebounce = millis();
    btnState = btnReading;
  }

  // Check if the different between current time and prevDebounce is greater than 50
  if ( ) { 
    btnPrevValue = btnValue;
    btnValue = btnState;
  }

  // If button value changed from LOW to HIGH increment counter and print 
  
}


sketch.ino

diagram.json

# Problem Statement - Pushbutton Debouncing

Design and implement an Arduino program that counts the number of times a 
button is pressed and displays the count on the Serial Monitor. 
The program should include debouncing logic to ensure that each button press is accurately counted.


### Requirements:
1. **Button Input**: The button is connected to pin 12 with an internal pull-up resistor.
2. **Debouncing**: Implement debouncing logic with a debounce time of 50 milliseconds.
3. **Counting Presses**: Increment a counter each time the button is pressed and released.
4. **Serial Output**: Print the current count to the Serial Monitor each time the button is pressed.

### Sample Output

```
Pressed 1 times
Pressed 2 times
Pressed 3 times
Pressed 4 times
Pressed 5 times
Pressed 6 times
```