#include <Servo.h>
Servo myservo;
int servo_motor = 10;
int led=11;
int pir=12;

void setup() {
  // put your setup code here, to run once:
  pinMode(pir, OUTPUT);
  pinMode(led, OUTPUT);
  myservo.attach(9);
  Serial.begin(9600);
}

void loop() {
  // put your main code here, to run repeatedly:
  int value_of_pir = digitalRead(pir);
  if(value_of_pir ==HIGH){
    digitalWrite(led, HIGH);
    myservo.write(180);
    Serial.println("Motion Detected!! Watch out!!!");
  } else {
    digitalWrite(led, LOW);
    myservo.write(0);
    Serial.println("Motion completed, no presencesses");
  }
}