#include <LiquidCrystal_I2C.h>

const int trigPin1 = 13;  // Sensor 1 mendeteksi masuk (Entrance)
const int echoPin1 = 12;
const int trigPin2 = 26;  // Sensor 2 mendeteksi keluar (Exit)
const int echoPin2 = 27;

long durasi1, durasi2;
float jarak1, jarak2;
int count = 0;  // Variabel counting objek

LiquidCrystal_I2C lcd(0x27, 16, 2); 

void setup() {
  Serial.begin(115200);
  pinMode(trigPin1, OUTPUT);
  pinMode(echoPin1, INPUT);
  pinMode(trigPin2, OUTPUT);
  pinMode(echoPin2, INPUT);

  lcd.init();
  lcd.backlight();
  lcd.setCursor(0, 0);
  lcd.print("SAMSUL HUDA");
  lcd.setCursor(0, 1);
  lcd.print("41422110059");
  delay(3000);
  lcd.clear();
}

void loop() {
  // Sensor 1 - Entrance
  digitalWrite(trigPin1, LOW);
  delayMicroseconds(2);
  digitalWrite(trigPin1, HIGH);
  delayMicroseconds(10);
  digitalWrite(trigPin1, LOW);
  
  durasi1 = pulseIn(echoPin1, HIGH);
  jarak1 = durasi1 * 0.034 / 2;

  // Sensor 2 - Exit 
  digitalWrite(trigPin2, LOW);
  delayMicroseconds(2);
  digitalWrite(trigPin2, HIGH);
  delayMicroseconds(10);
  digitalWrite(trigPin2, LOW);
  
  durasi2 = pulseIn(echoPin2, HIGH);
  jarak2 = durasi2 * 0.034 / 2;

  // Jika objek terdeteksijarak kurang dari 10 cm, dianggap objek masuk/terdeteksi
  if (jarak1 < 10) {
    count++;  // Tambahan counting objek
    lcd.setCursor(0, 0);
    lcd.print("OBJEK MASUK");
    lcd.setCursor(0, 1);
    lcd.print("COUNT: ");
    lcd.print(count);
    delay(2000);
    lcd.clear();
    
    Serial.println("Objek masuk terdeteksi.");
    Serial.print("Total Count: ");
    Serial.println(count);
  }

  // Jika objek terdeteksijarak kurang dari 10 cm, dianggap objek keluar
  if (jarak2 < 10 && count > 0) {  // Pastikan count tidak negatif
    count--;  // Kurangin counting objek
    lcd.setCursor(0, 0);
    lcd.print("OBJEK KELUAR");
    lcd.setCursor(0, 1);
    lcd.print("COUNT: ");
    lcd.print(count);
    delay(2000);
    lcd.clear();
    
    Serial.println("Objek keluar terdeteksi.");
    Serial.print("Total Count: ");
    Serial.println(count);
  }

  // Status serial monitor
  if (count == 0) {
    Serial.println("Semua objek telah keluar, area kosong.");
  } else {
    Serial.print("Jumlah objek di area: ");
    Serial.println(count);
  }

  delay(500);  // Delay 
}