//**********BLYNK, identitas device*****************************
#define BLYNK_TEMPLATE_ID "TMPL67OcuaERX"
#define BLYNK_TEMPLATE_NAME "buzzer dht"
#define BLYNK_AUTH_TOKEN "JkPTillAEh_j80bMkOMa7in1iH8oVffe"

//**********BLYNK, library**************************************
#include "DHTesp.h"
#include <BlynkSimpleEsp32.h>
BlynkTimer timer;

//**********BLYNK, ssid, pass, token****************************
char auth[] = BLYNK_AUTH_TOKEN;
char ssid[] = "Wokwi-GUEST";
char pass[] = "";

//*****ULTRASONIK, menamai pin yang digunakan****************
const int DHT_PIN = 15;
DHTesp dhtSensor;
float suhu = 0;
float kelembaban = 0;

//*****BLYNK, kirim nilai sensor*****************************
void sendSensor()
{
   //*****ULTRASONIK, membaca jarak**************************
   dhtSensor.setup(DHT_PIN, DHTesp::DHT22);

  TempAndHumidity data = dhtSensor.getTempAndHumidity();
  float suhu = data.temperature;
  float kelembaban = data.humidity;

  //*****SERIAL MONITOR, menampilkan data jarak**************
  Serial.print("Temp: ");
  Serial.print(suhu);
  Serial.println("C");
  Serial.print("Hum: ");
  Serial.print(kelembaban);
  Serial.println("%");

  //*****BLYNK, kirim nilai sensor*****************************
  Blynk.virtualWrite(V1, suhu);
  Blynk.virtualWrite(V2, kelembaban);
}


void setup() {
  //*****SERIAL MONITOR, setting baud rate*******************
  Serial.begin(115200);

  //*****ULTRASONIK, setting pin yang digunakan**************
 dhtSensor.setup(DHT_PIN, DHTesp::DHT22);

  //********BLYNK, mulai koneksi ke blynk***********************
  Blynk.begin(auth, ssid, pass);
  timer.setInterval(1000L, sendSensor);
}

void loop() {
  //********BLYNK, menjalankan blynk****************************
  Blynk.run();
  timer.run();
}