#include <LiquidCrystal.h>
/*
 * Pin 1 --- Ground
 * Pin 2 --- VDD Power for the LCD
 * Pin 4 --- Register Select (RS)
 * Pin 5 --- Read / Write select (R/W)
 * Pin 6 --- Enable (E)
 * Pin 11 -- Data line (D4) 4-bits at a time
 * Pin 12 -- Data line (D5) 4-bits at a time
 * Pin 13 -- Data line (D6) 4-bits at a time
 * Pin 14 -- Data line (D7) 4-bits at a time
 * Pin 15 -- Backlight Power
 * Pin 16 -- Backlight Ground (GND) remember 220 ohms resistor
 */
const int rs = 7;   // Pin 7  on Arduino to pin 4  (RS) LCD 
const int en = 6;   // Pin 6  on Arduino to pin 6  (E)  LCD 
const int d4 = 12;  // Pin 12 on Arduino to pin 11 (D4)  LCD
const int d5 = 10;  // Pin 10 on Arduino to pin 12 (D5)  LCD 
const int d6 = 9;   // Pin 9  on Arduino to pin 13 (D6) LCD
const int d7 = 8;   // Pin 8  on Arduino to pin 14 (D7) LCD
LiquidCrystal lcd(rs, en, d4, d5, d6, d7);
void setup() {
  // Set up the LCD's number of columns and rows:
  lcd.begin(16, 2);
  // Print Hello World! to the LCD.
  lcd.print("   TALLER DE ");
}
void loop() {
  // The location of line one is 0
  // The location of line two is 1
  // set the cursor to column 0, line 1 the print the second line
  lcd.setCursor(0, 1);
  lcd.print("  INNOVACION  ");
  //lcd.print(millis() / 1000);
}