const int led1Pin = 6;  // Pin connected to led1
const int led2Pin = 4;  // Pin connected to led2
const int switchPin = 2; // Pin connected to the slide switch

void setup() {
  pinMode(led1Pin, OUTPUT);
  pinMode(led2Pin, OUTPUT);
  pinMode(switchPin, INPUT_PULLUP); // Use internal pull-up resistor
}

void loop() {
  // Read the state of the switch
  int switchState = digitalRead(switchPin);

  if (switchState == LOW) { // Switch is ON
    digitalWrite(led1Pin, HIGH); // Turn on led1
    digitalWrite(led2Pin, LOW);  // Turn off led2
    delay(1);
  } else { // Switch is OFF
    digitalWrite(led1Pin, LOW);   // Turn off led1
    digitalWrite(led2Pin, HIGH);  // Turn on led2
    delay(1);
  }

  
}