#include <IRremote.h>
#define PIN_Receiver 2
IRrecv receiver(PIN_Receiver);

#define Load1 8
#define Load2 9

void setup() {
  // put your setup code here, to run once:
  receiver.enableIRIn();
  Serial.begin(9600);
  delay(3000);
  Serial.print("Program Started.\n\n");

  pinMode(Load1, OUTPUT);
  pinMode(Load2, OUTPUT);

}

void loop() {
  // put your main code here, to run repeatedly:
  if (receiver.decode()) {
    Serial.print("Command Value: ");
    Serial.println(receiver.decodedIRData.command);
    Serial.print("\t Button Pressed- ");

    getButton();
    receiver.resume();
    Serial.print("\n\n");
  }

}

void getButton() {
  switch(receiver.decodedIRData.command){
    case 162:
      Serial.print("Power");
      break;
    case 226:
      Serial.print("MENU");
      break;
    case 34:
      Serial.print("TEST");
      break;
    case 2:
      Serial.print("PLUS");
      break;
    case 194:
      Serial.print("BACK");
      break;
    case 224:
      Serial.print("PREV");
      break;
    case 168:
      Serial.print("PLAY");
      break;
    case 144:
      Serial.print("NEXT");
      break;
    case 152:
      Serial.print("MINUS");
      break;
    case 176:
      Serial.print("key: C");
      break;
    case 104:
      Serial.print("num: 0");
      break;
    case 48:
      Serial.print("num: 1");
      digitalWrite(Load1, HIGH);
      delay(1000);
      digitalWrite(Load1, LOW);
      break;
    case 24:
      Serial.print("num: 2");
      digitalWrite(Load2, HIGH);
      delay(1000);
      digitalWrite(Load2, LOW);
      break;
    case 122:
      Serial.print("num: 3");
      break;
    case 16:
      Serial.print("num: 4");
      break;
    case 56:
      Serial.print("num: 5");
      break;
    case 90:
      Serial.print("num: 6");
      break;
    case 66:
      Serial.print("num: 7");
      break;
    case 74:
      Serial.print("num: 8");
      break;
    case 82:
      Serial.print("num: 9");
      break;
    default:
      Serial.print("other button");
      break;
  }
}