/*
  LiquidCrystal Library - Hello World

  Demonstrates the use a 16x2 LCD display.  The LiquidCrystal
  library works with all LCD displays that are compatible with the
  Hitachi HD44780 driver. There are many of them out there, and you
  can usually tell them by the 16-pin interface.

  This sketch prints "Hello World!" to the LCD
  and shows the time and the value of analogue input A7

  The circuit:
   LCD RS pin to digital pin 8
   LCD Enable pin to digital pin 9
   LCD D4 pin to digital pin 4
   LCD D5 pin to digital pin 5
   LCD D6 pin to digital pin 6
   LCD D7 pin to digital pin 7
   LCD R/W pin to ground
   LCD VSS pin to ground
   LCD VCC pin to 5V
   10K resistor:
   ends to +5V and ground
   wiper to LCD VO pin (pin 3)
   analogue input to Nano A7

  Library originally added 18 Apr 2008
  by David A. Mellis
  library modified 5 Jul 2009
  by Limor Fried (http://www.ladyada.net)
  example added 9 Jul 2009
  by Tom Igoe
  modified 22 Nov 2010
  by Tom Igoe
  modified 7 Nov 2016
  by Arturo Guadalupi
  this sketch modified 24th Nov 2021
  by Timothy Davies


*/

// include the library code:
#include <LiquidCrystal.h>

// initialize the library by associating any needed LCD interface pin
// with the arduino pin number it is connected to
const int rs = 8, en = 9, d4 = 4, d5 = 5, d6 = 6, d7 = 7;
LiquidCrystal lcd(rs, en, d4, d5, d6, d7);

// define the left and right push buttons
const int left = 11, right = 10;

void setup() {
  // set up the LCD's number of columns and rows:
  lcd.begin(16, 2);

// Print a message to the LCD.
  lcd.print("hello, world!");

  pinMode(left, INPUT_PULLUP);
  pinMode(right, INPUT_PULLUP);
}

void loop() {
  // set the cursor to column 0, line 1
  // (note: line 1 is the second row, since counting begins with 0):
  lcd.setCursor(0, 1);

// print the number of seconds since reset:
  lcd.print(millis() / 1000);

  //move the cursor to the middle of the second line
  lcd.setCursor(6, 1);
  
  //print the message with extra spaces to blank previous analogue data
  lcd.print("ADC =     ");
  
  //move the cursor to the printing position for the analogue data
  lcd.setCursor(12, 1);
  
  //print the value of analogue input A7 as 0 to 1023
  lcd.print(analogRead(7));

  if (digitalRead(left) == 0)
  { 
    lcd.setCursor(14, 0);
    lcd.print("L");
  }
  else if (digitalRead(right) == 0)
  { 
    lcd.setCursor(14, 0);
    lcd.print(" R");
  }
  else {
    lcd.setCursor(14, 0);
    lcd.print("  ");
  }
  delay(100);
}