//Hariharnath Paduchuru Working Demo
#include <WiFi.h>
#include "secrets.h"
#include <WiFiClientSecure.h>
#include <PubSubClient.h>
#include <ArduinoJson.h>
#include "WiFi.h"
#include "DHTesp.h"

const int DHT_PIN = 15;
DHTesp dhtSensor;
#define AWS_IOT_PUBLISH_TOPIC   "iotfrontier/pub"
#define AWS_IOT_SUBSCRIBE_TOPIC "iotfrontier/sub"
String h ;
String t;
WiFiClientSecure net = WiFiClientSecure();
PubSubClient client(net);
 
void connectAWS()
{
  WiFi.mode(WIFI_STA);
  WiFi.begin(WIFI_SSID, WIFI_PASSWORD);
 
  Serial.println("Connecting to Wi-Fi");
 
  while (WiFi.status() != WL_CONNECTED)
  {
    delay(500);
    Serial.print(".");
  }
 
  // Configure WiFiClientSecure to use the AWS IoT device credentials
  net.setCACert(AWS_CERT_CA);
  net.setCertificate(AWS_CERT_CRT);
  net.setPrivateKey(AWS_CERT_PRIVATE);
 
  // Connect to the MQTT broker on the AWS endpoint we defined earlier
  client.setServer(AWS_IOT_ENDPOINT, 8883);
 
  // Create a message handler
  client.setCallback(messageHandler);
 
  Serial.println("Connecting to AWS IOT");
 
  while (!client.connect(THINGNAME))
  {
    Serial.print(".");
    delay(100);
  }
 
  if (!client.connected())
  {
    Serial.println("AWS IoT Timeout!");
    return;
  }
 
  // Subscribe to a topic
  client.subscribe(AWS_IOT_SUBSCRIBE_TOPIC);
 
  Serial.println("AWS IoT Connected!");
}
 
void publishMessage()
{
  StaticJsonDocument<200> doc;
  doc["humidity"] = h;
  doc["temperature"] = t;
  char jsonBuffer[512];
  serializeJson(doc, jsonBuffer); // print to client
 
  client.publish(AWS_IOT_PUBLISH_TOPIC, jsonBuffer);
}
 
void messageHandler(char* topic, byte* payload, unsigned int length)
{
  Serial.print("incoming: ");
  Serial.println(topic);
 
  StaticJsonDocument<200> doc;
  deserializeJson(doc, payload);
  const char* message = doc["message"];
  Serial.println(message);
}

void setup() {
  Serial.begin(115200);
  Serial.print("Connecting to WiFi");
  WiFi.begin("Wokwi-GUEST", "", 6);
  while (WiFi.status() != WL_CONNECTED) {
    delay(100);
    Serial.print(".");
  }
  Serial.println(" Connected!");
  dhtSensor.setup(DHT_PIN, DHTesp::DHT22);
  connectAWS();
}

void loop() {
  TempAndHumidity  data = dhtSensor.getTempAndHumidity();
  h = String(data.temperature, 2);
  t = String(data.humidity, 1);
  Serial.println("Temp: " + String(data.temperature, 2) + "°C");
  Serial.println("Humidity: " + String(data.humidity, 1) + "%");
  Serial.println("---");
  delay(2000); // Wait for a new reading from the sensor (DHT22 has ~0.5Hz sample rate)
  publishMessage();
  client.loop();
  delay(5000);

}