#define BLYNK_TEMPLATE_ID "TMPL6HOOeVP6I"
#define BLYNK_TEMPLATE_NAME "ESP32 mutiara"
#define BLYNK_AUTH_TOKEN "GbJBPmYRAqseGqUy7k9eNvGUzbZLioUv"
#define BLYNK_PRINT Serial

#include <WiFi.h>
#include <WiFiClient.h>
#include <BlynkSimpleEsp32.h>
#include <DHT.h>

char auth[] = BLYNK_AUTH_TOKEN;

char ssid[] = "Wokwi-GUEST"; 
char pass[] = ""; 

#define DHTPIN 5          // Pin untuk DHT
#define DHTTYPE DHT22     
DHT dht(DHTPIN, DHTTYPE);
BlynkTimer timer;

#define LED1_PIN 2        // Pin untuk LED 1
#define LED2_PIN 4        // Pin untuk LED 2

void setup() {
   Serial.begin(115200);
   Blynk.begin(auth, ssid, pass);
  
   dht.begin();
   timer.setInterval(2500L, sendSensor);
   
   pinMode(LED1_PIN, OUTPUT);
   pinMode(LED2_PIN, OUTPUT);
   digitalWrite(LED1_PIN, LOW); 
   digitalWrite(LED2_PIN, LOW); 
}

void loop() {
  Blynk.run();
  timer.run();
}

void sendSensor() {
  float h = dht.readHumidity();
  float t = dht.readTemperature();
  if (isnan(h) || isnan(t)) {
    Serial.println("Failed to read from DHT sensor!");
    return;
  }

  Blynk.virtualWrite(V1, h); // Mengirimkan kelembapan ke Blynk
  Blynk.virtualWrite(V0, t); // Mengirimkan suhu ke Blynk
  Serial.print("Temperature : ");
  Serial.print(t);
  Serial.print("    Humidity : ");
  Serial.println(h);
  

  // Kontrol LED berdasarkan suhu
  if (t > 35) {
    digitalWrite(LED1_PIN, HIGH); // Nyalakan LED1 jika suhu > 35
  } else {
    digitalWrite(LED1_PIN, LOW); // Matikan LED1
  }

  // Kontrol LED berdasarkan kelembapan
  if (h > 80) {
    digitalWrite(LED2_PIN, HIGH); // Nyalakan LED2 jika kelembapan > 80
  } else {
    digitalWrite(LED2_PIN, LOW); // Matikan LED2
  }

}