#define BLYNK_PRINT Serial
#include <ESP32Servo.h>
#include <WiFi.h>
#include <WiFiClientSecure.h>
#include <BlynkSimpleEsp32.h>  // Include the Blynk library for ESP32

#define BLYNK_TEMPLATE_ID "TMPL6V2sCAw8G"
#define BLYNK_TEMPLATE_NAME "ULTRASONIK BLYNK"
#define BLYNK_AUTH_TOKEN "zQzEcBMSbCqfcCJsoanzJPcTGM_YPaOV"

char ssid[] = "Wokwi-GUEST";       // Replace with your Wi-Fi SSID
char pass[] = "";                  // Replace with your Wi-Fi password


// Pin setup
const int trigPin = 5;
const int echoPin = 18;
const int ledPin = 2;
const int servoPin = 4;

// Threshold distances in centimeters
const int distanceThreshold = 200;  // 2 meters
const int closeDistanceThreshold = 30;  // 30 cm

Servo myServo;

void setup() {
  // Initialize pins
  pinMode(trigPin, OUTPUT);
  pinMode(echoPin, INPUT);
  pinMode(ledPin, OUTPUT);

  // Attach the servo
  myServo.attach(servoPin, 500, 2400); // Attach with PWM limits for ESP32
  myServo.write(0); // Initial servo position

  Serial.begin(115200);

  // Initialize Blynk with the authentication token and Wi-Fi credentials
  Blynk.begin(BLYNK_AUTH_TOKEN, ssid, pass);
}

BLYNK_WRITE(VO){
 int ledValue = param.asInt();
 ledValue == ledPin;
}

void loop() {
   Blynk.run();
  // Measure distance
  long duration, distance;
  
  // Trigger the ultrasonic pulse
  digitalWrite(trigPin, LOW);
  delayMicroseconds(2);
  digitalWrite(trigPin, HIGH);
  delayMicroseconds(10);
  digitalWrite(trigPin, LOW);
  
  // Read the echo pulse duration
  duration = pulseIn(echoPin, HIGH);
  
  // Calculate distance in centimeters
  distance = duration * 0.034 / 2;

  Serial.print("Distance: ");
  Serial.print(distance);
  Serial.println(" cm");

  // Condition for distance less than 2 meters and more than 30 cm
  if (distance >= distanceThreshold ) {
    digitalWrite(ledPin, HIGH);    // Turn LED on
    myServo.write(90);             // Move servo to 90 degrees
  } 
  // Condition for distance 30 cm or less
  else if (distance <= closeDistanceThreshold) {
    digitalWrite(ledPin, LOW);     // Turn LED off
    myServo.write(0);              // Move servo to 0 degrees
  }

  delay(500);  // Delay for stability
}