///EJEMPLO MONITOR SERIAL//////
//Puertos GPIO 
int led=13;

//Variables status
int status_sensor=0;

void setup() {
  // put your setup code here, to run once:
Serial.begin(115200);
pinMode(led, OUTPUT);// Configurar puerto 13 como salida
}

void loop() {
  // put your main code here, to run repeatedly:
  status_sensor=analogRead(A5);
  Serial.print("Estado sensor Analogo= ");
  Serial.println(status_sensor);

  if(status_sensor>512){
    digitalWrite(led,HIGH);
  }
  else{
    digitalWrite(led,LOW);
  }
}