#include <Wire.h>

// Pin for relay module set as output
const int relayPin = 8;
bool relayState = LOW;
int counter = 1;

void setup() {
    Serial.begin(9600);
    pinMode(relayPin, OUTPUT);
    digitalWrite(relayPin, LOW);
    Serial.println("RELAY OFF");
}

void loop() {
    float temperature = 101; // Simulated temperature reading
    Serial.print(counter); 
    Serial.print(" Temp: "); 
    Serial.print(temperature, 1); 
    Serial.println("*F");

    if (temperature > 100 && !relayState) {
        activateRelay();
    }

    counter++;
    delay(5000); // Delay for 5 seconds (simulate your 10-minute interval as needed)
}

void activateRelay() {
    digitalWrite(relayPin, HIGH);
    relayState = HIGH;
    Serial.println("RELAY ON");
    delay(2000); // Relay active for 2 seconds
    digitalWrite(relayPin, LOW);
    relayState = LOW;
    Serial.println("RELAY OFF");
}