// RGB LED:
// Connect the common cathode (longest leg) of the RGB LED to the GND pin on the Arduino.
// Connect the red anode to digital pin 9 on the Arduino through a 220-ohm resistor.
// Connect the green anode to digital pin 10 on the Arduino through a 220-ohm resistor.
// Connect the blue anode to digital pin 11 on the Arduino through a 220-ohm resistor.

const int redPin = 9;
const int greenPin = 10;
const int bluePin = 11;

void setup() {
  pinMode(redPin, OUTPUT);
  pinMode(greenPin, OUTPUT);
  pinMode(bluePin, OUTPUT);
}

void loop() {
  setColor(255, 0, 0); // Red
  delay(1000);
  setColor(0, 255, 0); // Green
  delay(1000);
  setColor(0, 0, 255); // Blue
  delay(1000);
  setColor(255, 255, 0); // Yellow
  delay(1000);
  setColor(0, 255, 255); // Cyan
  delay(1000);
  setColor(255, 0, 255); // Magenta
  delay(1000);
  setColor(255, 255, 255); // White
  delay(1000);
}

void setColor(int red, int green, int blue) {
  analogWrite(redPin, red);
  analogWrite(greenPin, green);
  analogWrite(bluePin, blue);
}