int xValue = 0;
int yValue = 0;
int sw;

void setup() {
  // put your setup code here, to run once:
  pinMode(8, INPUT_PULLUP); //we need to put a resistor to the push button //In arduino we have inbuilt Pull up resistor so we used it //try putting a resistor in button and pin 8
  Serial.begin(9600);
}

void loop() {
  // put your main code here, to run repeatedly:
  xValue = analogRead(A0);
  yValue = analogRead(A1);
 
  sw = digitalRead(8);

  Serial.print("X: ");
  Serial.print(xValue);

  Serial.print(",Y: ");
  Serial.print(yValue);
  
  Serial.print(",Button: ");
  if(sw==LOW){
    Serial.print("Button Pressed!");
  }
  else{
    Serial.print("Button Not Pressed!");
  }
  Serial.println(" ");
  delay(500);
}